It was added to allow a user-defined ARP request source IP address instead of the requirement to use the default source IP address of 0.0.0.0. This latest Command Line Interface (CLI) command was introduced through Cisco bug ID CSCtn27420 in Cisco IOS Version 15.2(2)E. Ip device tracking probe auto-source fallback #Windows duplicate detector codeThis command format is for newer code versions: #Windows duplicate detector seriesThis command was implemented in Cisco IOS Version 12.2(55)SE on 2900, 3500, and 3700 Series Switch platforms, and in Version 15.1(1)SG on the 4500 Series Switch platform. SVI is not currently available on the 6500 Series Switch platform. This method is difficult to scale, so Cisco recommends to use the IP device-tracking probe delay as the primary method. #Windows duplicate detector windowsThe caveat to this method is that an SVI must exist on every switch in every VLAN where Microsoft Windows clients who run DHCP reside. This configuration currently does not trigger the duplicate address detection error message in Microsoft Windows. This command format is for older code versions: Thus, it is certain the duplicate IP address error does not occur. If an SVI is configured for the Virtial Local Area Network (VLAN) and either of the two commands that follow are used, then the sender IP address in the IP Device Tracking (IPDT) probes is never 0.0.0.0. #Windows duplicate detector Pc
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |